7-17
7
Press the [2] key (TYPE No.).
TYPE No. screen is displayed.
8
Press the POSITION ( ) keys and select the TYPE No.
Supplement
•
CUT L and UP L is displayed when the TYPE
No. 0-7 is selected. Also, you will be able to
set the UP MODE.
•
Setting for all becomes enabled when USER
is selected.
•
Nothing will be displayed when "OFF" is
selected.
•
If the CUT LENGTH is too long or the UP
LENGTH is too short, the media may get
caught.
In that case, adjust BLADE LENGTH, CUT
LENGTH and UP LENGTH.
9
Conrm the setting and press the [ESC] key (PREVIOUS).
TYPE No. will be selected and it will return to CUT LINE PATTERN
screen.
Supplement
You can set the range between 1 and 38, and
"UP".
10
Press the POSITION ( ) key (UP MODE).
UP MODE screen is displayed.
Supplement
•
Value set here will be the cut force for the
uncut part of the perforated lines. Tool will be
raised when set to "UP".
•
Normally, input the smaller value than the
FORCE for cutting to make it half cutting.
11
Press the POSITION ( ) keys and set the UP MODE.
12
Conrm the setting and press the [ESC] key (PREVIOUS).
It will return to UP MODE CUT LINE PATTERN screen.
To Next Page
Loading...
