GRAPHTEC CE7000-130AP - Page 180

9-12
3
Press the POSITION ( ) key.
INTERFACE screen (2/4) is displayed.
Supplement
It will return to INTERFACE screen (2/4) without
changing the settings when you press the [ESC]
key (CANCEL).
4
Press the [2] key (RS-232C).
RS-232C setting screen is displayed.
Supplement
Baud rate can be selected from 19200, 9600,
4800, 2400, 1200, 600 or 300.
5
Press the [1] key (BAUD RATE).
BAUD RATE screen is displayed.
Supplement
Match it to the software you are using.
6
Press the POSITION ( ) keys and increase or decrease the
setting value.
7
Conrm the setting and press the [ESC] key (PREVIOUS).
The baud rate is selected and it will return to RS-232C setting screen.
8
Press the [2] key (DATA BIT).
DATA BIT screen is displayed.
Supplement
•
Match it to the software you are using.
•
It will return to RS-232C setting screen (2/3)
without changing the settings when you press
the [ESC] key (PREVIOUS).
9
Press the [1] key (8 BIT) or the [2] key (7 BIT).
The data bit will be selected and it will return to RS-232C setting screen.