4-12
Operation
1
Plot (cut) the data you want to copy once.
Cutting data is stored in the buffer memory.
2
Press the POSITION (
) keys and move the tool
carriage to the position to copy.
Supplement
•
When setting the copy interval, set "MEDIA
CHANGE MODE" to OFF.
•
NO DATA FOR COPY IN BUFFER!" is
displayed if there is no data in the buffer
memory. Send the cutting data.
•
If too much data is sent from the buffer
memory, "1 copy in the Copy mode buffer!"
will be displayed.
•
If the data to be copied is larger than the
cutting area, "Cannot copy, the valid area is
too small" will be displayed.
3
Press the [COPY] key
COPY MODE screen is displayed.
4
Press the [1] key (MEDIA CHANGE MODE).
MEDIA CHANGE MODE screen is displayed.
5
Press the [1] key (OFF).
Confirm the settings and it will return to the COPY MODE screen.
6
Press the [2] key (NUMBER OF COPIES).
NUMBER OF COPIES screen is displayed.
Supplement
•
Number of copies can be set as much as it
can t in the media set on the printer.
•
The initial value for the number of copies is
always 1.
7
Press the POSITION ( ) keys and increase or decrease the
setting value.
To Next Page
Loading...
