C-5
Chapter 8: Settings Regarding Cutting Time
8.1 Sorting the Cutting Data .............................................8-2
8.2 Perform Automatic Pre Feed When Cut Data is Received ..................8-4
8.3 Perform Automatic Pre Feed When Media is Set (Initial Feed) ..............8-6
8.4 Setting Feed Speed for Pre Feed ...................................... 8-7
8.5 Setting the MOVING SPEED ..........................................8-9
8.6 Setting the Tool Up Move ........................................... 8 -11
8.7 Setting the Tool Up Height ..........................................8 -13
Chapter 9: Setting Regarding Interface
9.1 Setting Interface ....................................................9-2
USB interface ...............................................................9-2
Network (LAN) interface ......................................................9-3
RS-232C interface ...........................................................9-3
9.2 Clearing the Buffer Memory ..........................................9-4
9.3 I/F (LAN) ..........................................................9-5
Setting the DHCP ..........................................................9-5
Set IP address, subnet mask, gateway ..........................................9 -7
9.4 Connecting with RS-232C ...........................................9 -10
Switching the setting number you want to use ...................................9 -10
Changing/storing the RS-232C setting .........................................9 -11
Chapter 10: Settings Regarding Operation Environment
Related to menu display .....................................................10- 2
Display language setting (LANGUAGE SELECTION) ..............................10 -2
Display Length Unit Setting (LENGTH UNIT) ....................................10- 3
Related to sensor ...........................................................10 - 4
Enabling/Disabling the media sensors (MEDIA SENSOR) ..........................10 -4
Enabling/Disabling the push roller sensors (PUSH ROLLER SENSOR) ................10 - 5
Related to plotter environment .................................................10 -7
Fan suction setting (FAN POWER) ............................................10 -7
Enabling/Disabling the beep setting (BEEP FOR KEY OPERATION) .................10 - 8
Pause key select setting (Selecting PAUSE key) ..................................10 -9
Simple mode / Normal mode setting (Simple mode / Normal mode) .................10 -10
LCD contrast setting (LCD contrast) ..........................................10 -11
Chapter 11: Settings of Controls from Computer
Related to command processing ...............................................11- 2
Setting the command (COMMAND) ...........................................11- 2
Priority of tool condition selection (CONDITION PRIORITY) ........................11- 3
Related to GP-GL command ..................................................11- 4
Setting the step size (GP-GL STEP SIZE) .......................................11- 4
Enabling/Disabling the ' : ' and ' ; ' commands (COMMAND ' : ', ' ; ') ..................11- 5
Moving the pen while raised or lowered in Response to the 'W' command (COMMAND 'W') 11- 6
Related to HP-GL command .................................................. 11-7
Model ID response (HP-GL MODEL EMULATED) ................................ 11-7
Circle-command resolution setting (CIRCLE RESOLUTION) ........................11- 8
To Next Page
Loading...
