GRAPHTEC CE7000 Series - Page 16

C-6
Chapter 12: Data Link
12.1 Select Connection Destination .......................................12- 2
12.2 Data Link with USB Memory .........................................12-3
12.3 Output with a Bar Code .............................................12- 5
12.4 Start Mark Auto Scan ...............................................12-8
12.5 Communication Timeout ...........................................12-10
12.6 Skew Scanning ................................................... 12-12
Chapter 13: Cutting with supplied application software
13.1 Basic operation of printing and cutting ................................13 -2
Graphtec Pro Studio / Cutting Master 4 ..........................................13 -2
Graphtec Studio ...........................................................13 -11
13.2 Basic operation of bar code ........................................13 -15
Graphtec Pro Studio / Cutting Master 4 .........................................13 -15
13.3 Application of barcode cutting (continuous operation) ..................13 -23
Graphtec Pro Studio ...................................................... 13 -23
Chapter 14: Maintenance
14.1 Daily Maintenance .................................................14 -2
Daily maintenance ..........................................................14 -2
Storing the plotter ..........................................................14 -2
14.2 Replacing Cutter Blade .............................................14 -3
14.3 Cleaning the Cutter Pen ............................................14 -5
14.4 Cutter Plunger Exchange ...........................................14 -6
14.5 Setting the Alarm for Degree of Wear (BLADE WEAR ALARM) ............14 -7
Chapter 15: Troubleshooting
15.1 Troubleshooting ...................................................15- 2
When the plotter does not operate after turning the power on ........................15 -2
When it does not work right ...................................................15 - 3
When the Cutting Result is Not Good ...........................................15 -5
Error Messages in GP-GL Command Mode ......................................15 -6
Error Messages in HP-GL Command Mode ......................................15 -7
ARMS Error Messages ......................................................15 -9
Other Error Messages ......................................................15 -12
Caution Message ..........................................................15 -15
15.2 Printing the Setting of the Plotter ....................................15 -16
15.3 Creating Test Pattern ..............................................15 -18
15.4 Creating CUTTING PRO ............................................15 -2 0
15.5 Conrm the Cutting Data ...........................................15 -22
15.6 Self Diagnostic Test ...............................................15 - 24
Reading the error message ................................................. 15 -26