GRAPHTEC CE7000 Series - Page 259

13-5
Step 2: Create design data for printing and cutting.
Design the drawing pattern that you want to print and the countour to be cut.
Operation
2-
1 Create print design for printing and cutting.
Feed direction of media
Feed direction of media
MARK TYPE 1 MARK TYPE 2
2-
2 Create cut design for printing and cutting.
When using Graphtec Pro Studio
Supplement
If this setting is not performed, "Step 4: Cut the
printed media" - "Contour Cut Mark" icoin in
Step 4-2 is not enabled.
1
Select the print data and select "Effects" - "Contour Cut
Mark".
Select the offset value of contour on the "DesignCentral"
screen.
2
Press the on the "DesignCentral" screen.
Cutting data is created on the design screen.
Feed direction of media
Feed direction of media
MARK TYPE 1 MARK TYPE 2
Cutting data