13-6
When using Cutting Master 4
1
It's recommenedd that the cut design is created on a layer
different from the print design.
Feed direction of media
Feed direction of media
MARK TYPE 1 MARK TYPE 2
Cutting data
Step 3: Print design data.
After creating the design, print it on the media.
Supplement
Pay attention to the following when printing to prevent registration mark scan from failing when cutting.
•
Set the enlarge/shrink scale to 100%.
•
Set the printing position (center/lower left etc.) so that the positional relationship between the created document and the printed
result is the same.
Operation
3-
1 Print design data for printing and cutting.
When using Graphtec Pro Studio
1
Select the printer to use from the Print menu of Graphtec
Pro Studio and print the created data.
When using Cutting Master 4
1
Print using the Adobe Illustrator or Corel DRAW function.
Set the layer of cut data to Hide before printing.
To Next Page
Loading...
