13-13
Step 4: Cut the printed media.
Cut the media prepared in Step 3 with the cutting plotter.
Operation
Supplement
For loading media, see "Loading Media (Paper
or Marking Film)".
4-
1 Load the printed media on the cutting plotter.
Feed direction of media
Feed direction of media
MARK TYPE 1 MARK TYPE 2
4-
2 Open the "Congure Cut Job" screenl.
Select the "By Color" from the "Apply Conditions" and select
the color to cut.
Supplement
The ROTATE can be set only when using
4POINTS.
For other registration marks, load the media
according to the orientation of the preview.
4-
3 Open the "Page" screen.
Set the ROTATE to "0°" to match the setting direction of the
media.
To Next Page
Loading...
