13-14
4-
4 Open the "Cutting Plotter" screen.
4-
5 Using the cutting plotter's POSITION (
) key, move
the tool to the lower right registration mark (within the red
rectangle).
Feed direction of media
Feed direction of media
MARK TYPE 1 MARK TYPE 2
Move here Move here
Supplement
If a registration mark scanning error occurs,
check the registration marks etc. (See "ARMS".)
4-
6 Press the "Send to cutter".
When registration mark scanning starts and all registration
marks is completed to scan, cutting starts.
To Next Page
Loading...
