13-26
When using Cutting Master 4
1
In Adobe Illustrator, select "Cutting Master 4" -
"Registration Marks" from the File menu.
In Corel DRAW, select "Launch" - "Registration Marks
(CM4)" from the tool bar.
Set type, thickness and length of registration mark.
Check the "Use Barcode".
Select the "Roll Media" from the "Barcode Type".
The margins of the printer driver selected in the
application are initialized in "Printer Margin". When
changing the printer, acquire margin information from the
"Get Printer Margin".
Press the “OK”.
* If selecting from the application launcher in CorelDRAW
version X7 or earlier and, the Registration Marks screen
will be displayed.
* The following screen is the screen when starting from
Adobe Illustrator.
Supplement
Registration marks are placed automatically.
The position cannot be changed.
2
Registration marks and bar code are created on the
design screen.
G1100JMAA-R
G1100JMAA-F
G1100JMAA-R
G1100JMAA-F
Feed direction of media
Feed direction of media
MARK TYPE 1 MARK TYPE 2
Bar code Bar code
To Next Page
Loading...
