13-27
Step 3: Print design data.
After creating the design, print it on the media.
Supplement
Pay attention to the following when printing to prevent registration mark scan from failing when cutting.
•
Set the enlarge/shrink scale to 100%.
•
Set the printing position (center/lower left etc.) to "Not change".
•
In continuous operation, it is necessary that two or more data are printed on the roll media.
It is convenient to prepare printing and cutting data in advance and print them collectively.
•
Print using the printer selected in "1. Prepare the design for data link (continuous operation)".
Operation
3-
1 See "13.1 Basic operation of printing and cutting" and print
the design with registration marks and roll media bar code for
printing and cutting.
Step 4: Save cutting data in data link server.
Create a job le and save it in the data link server.
Since cutting data and bar code information are recorded in this job le, the cutting plotter will be able to nd the
correct cutting data.
Operation
4-
1 Save the le for data link (continuous operation) in the
personal computer (data link server).
To Next Page
Loading...
