13-31
Step 5: Start data link server.
Start the data link server to send job le information to the cutting plotter.
Operation
5-
1 Start the data link server.
When using Graphtec Pro Studio
Supplement
•
The cutting plotter supports only one data
link server. Connecting two or more data link
servers to a single cutting plotter may not
work properly.
•
When using the data link server, do not use
USB connection and network connection at
the same time. Connect to the interface only
that uses the data link server.
•
When using a data link server with network
connection, always connect with a LAN cable.
When connecting with wireless (Wi-Fi), it may
not operate properly.
1
Press the "Data link" icon to start the data link server.
2
Each time the icon is clicked, start/stop of the datalink
server is switched.
In the start state, a red frame is displayed around the
icon.
Start Stop
To Next Page
Loading...
