GRAPHTEC CE7000 Series - Page 286

13-32
When using Cutting Master 4
Supplement
•
The cutting plotter supports only one data link
server. Connecting multiple data link servers
to a single cutting plotter may not work
properly.
•
When using the data link server, do not use
USB connection and network connection at
the same time. Connect to the interface only
that uses the data link server.
•
When using a data link server with network
connection, always connect with a LAN cable.
When connecting with wireless (Wi-Fi), it may
not operate properly.
1
Press the "Data link" icon to start the data link server.
2
Each time the icon is clicked, start/stop of the datalink
server is switched.
In the start state, a red frame is displayed around the
icon.
<Mac><Windows>
StartStart Stop Stop
<Windows>
<Mac>