GRAPHTEC CE7000 Series - Page 287

13-33
Step 6: Set up cutting plotter.
Set the data link connection method to receive cutting data from the data link server.
Operation
Supplement
Perform the settings in Normal mode.
6-
1 Press the [PAUSE / MENU] key.
MENU screen is displayed.
6-
2 Press the POSITION ( ) key (LINK).
DATA LINK screen (1/2) is displayed.
6-
3 Press the [1] key (DESTINATION).
DESTINATION screen is displayed.
Supplement
It is not necessary to set the IP address of the
data link server in the cutting plotter.
6-
4 Press the [2] key (SERVER (USB)) or the [3] key (SERVER
(LAN)).
* Select the connection method to the personal computer set
in "Step 5: Start data link server".
6-
5 Conrm the setting and press the [ENTER] key (SET).
Setting will be confirmed and it will return to DATA LINK screen (1/2).
6-
6 Press the [PAUSE/MENU] key.
It will return to default screen.