13-34
Step 7: Cut the printed media.
Cut the media prepared in Step 3 with the cutting plotter.
Operation
Supplement
For loading media, see "Loading Media (Paper
or Marking Film)".
7-
1 Load the printed media on the cutting plotter.
G1100JMAA-R
G1100JMAA-F
G1100JMAA-R
G1100JMAA-F
Feed direction of media
Feed direction of media
MARK TYPE 1 MARK TYPE 2
Bar code Bar code
Supplement
You can go from the MENU screen to the
Continuous Operation starting screen.
Press the [PAUSE/MENU] key in the
default screen. The following screen will be
displayed.
Press the [ ] key (LINK). The following
screen will be displayed.
Press the [4] key (Continuous Operation). The
following screen will be displayed.
7-
2 Press the [BARCODE] key in the default screen.
The following message is displayed.
To Next Page
Loading...
