13-35
Supplement
If the start mark cannot be scanned, check the
print result of start mark and the detect start
position etc.
7-
3 Using the POSITION (
) key, move the tool to the black
rectangle (red frame in gure) next to the bar code.
G1100JMAA-R
G1100JMAA-F
G1100JMAA-R
G1100JMAA-F
Feed direction of media
Feed direction of media
MARK TYPE 1 MARK TYPE 2
Move here Move here
Feed direction of media
Width of push roller
15mm
Align near the center of the width which is
the forward side of the start mark.
7-
4 Conrm the tool position and press the [ENTER] key.
Bar code scanning starts, the corresponding data is read
from the personal computer, and cutting starts when the
registration mark scanning is completed.
* In continuous operation, after cutting of the rst data is
completed, the cutting plotter automatically scans the bar
code, receive the data and repeat the cut without having to
perform the previous operation again.
* When media skews beyond the value set in "Skew
detection" of the cutting plotter, continuous operation is
stopped to prevent media misalignment .
For the "Skew detection", see the "Skew detection" in
Chapter 12.
To Next Page
Loading...
