I-3
Setting Initial Blade Control Position Adjust ........ 7-19
Setting length of the page ....................... 4-5
Setting mirror ................................. 4-7
Setting of the Initial Down Force .................. 7-6
Setting origin point when HP-GL is set ............. 3-9
Settings for Cutting ............................ 4-2
Setting speed of the registration mark scan ........ 5-25
Setting step movement distance .................. 3-4
Setting the acceleration ....................... 2-51
Setting the command ......................... 11-2
Setting the Cutting Direction .................... 3-10
Setting the DHCP ............................. 9-5
Setting the force ............................. 2-50
Setting the length of overcut ..................... 7-4
Setting the OFFSET FORCE ................... 7-21
Setting the Origin Point ......................... 3-7
Setting the speed ............................ 2-48
Setting the step size .......................... 11- 4
Setting the tangential mode ..................... 7-3
Setting the tool .............................. 2-46
Setting the tool condition ...................... 2-42
Setting tool No. .............................. 2-53
SETUP MANUAL ............................. 1-2
Sheet media ............................ 2-16, 2-18
Simple mode ........................... 2-34, 2-63
Simple mode setting ......................... 10-10
Skew Scanning ............................. 12-12
SLOW ..................................... 2-32
Software Activation Code ....................... 1-2
Sorting ...................................... 8-2
Speed and Force ............................. 2-44
Stand .................................... 1-7, 1-9
Start Mark Auto Scan ......................... 12-8
STEP PASS .................................. 7-8
Step Size ................................... 2-68
Stock shaft ............................... 1-7, 1-9
Stop Cutting ................................ 3-12
Stopper .................................. 1-7, 1-9
Subnet mask ................................. 9-7
Supplies ..................................... A-3
T
Tangential mode .............................. 7-2
TEST ...................................... 2-35
Test pattern ................................ 15-20
Test Pattern ................................ 15-18
Test the registration mark sensor ................ 5-14
TO ENSURE SAFE AND CORRECT USE Cutter. . . . . 1-2
TOOL ...................................... 2-35
Tool carriage .......................... 1-4, 1-6, 1-8
Tool holder ........................... , 1-4, 1-6, 1-8
TOOL UP HEIGHT ........................... 8-13
Tool up movement ............................ 8-11
U
UP mode ................................... 7-15
USB cable ................................... 1-2
USB interface ................................ 9-2
USB interface connector ................. 1-4, 1-6, 1-9
USB memory dedicated connector ......... 1-4, 1-7, 1-9
W
Water-based ber pen .......................... 1-2
Water-based ber pen adapter ................... 1-2
When media change mode is OFF ............... 4-10
When media change mode is ON ................ 4-13
To Next Page
Loading...
