GRAPHTEC FC4200-50 - Three-Point Registration Mark Alignment (3 POINT); Specifying Three-Point (3 POINT) Recognition

FC4200-UM-251-03-9370 60
TROUBLE SHOOTING
9.5 Error Messages in GP-GL Command Mode
Error message Cause Solution
ERROR 1
Command Error
The plotter received an
unrecognizable command.
Press the plotterʼs ENTER key.
When turning on the plotter to
which your software application
has output data, noise mixed into
the data input.
Your software applicationʼs output
device setting has changed.
Configure your software application
menu to permit Graphtec plotter control.
Re-specify the software applicationʼs
interface conditions.
The plotterʼs interface conditions
have changed.
Re-specify the plotterʼs interface
conditions.
ERROR 4
Parameter Overflow
The numeric parameter of an input
command exceeds its permissible
range.
Configure your software application
menu to permit Graphtec plotter control.
Re-specify the software applicationʼs
interface conditions.
Your software applicationʼs output
device setting has changed.
The plotterʼs interface conditions
have changed.
Re-specify the plotterʼs interface
conditions.
ERROR 5
I/O Error
An error related to the receipt of
data occurred within the interface.
Configure your software application
menu to permit Graphtec plotter control
Re-specify the software applicationʼs
interface conditions..
Your software applicationʼs output
device setting has changed.
The plotterʼs interface conditions
have changed.
Re-specify the plotterʼs interface
conditions.