FC4200-UM-251-03-9370 64
SPECIFYING THE PEN CONDITIONS
10.2 Selecting a Set of Cutting Conditions
Four different sets of user-defined cutting conditions can be registered in the plotterʼs memory as COND
Nos. 1 through 4. To specify a set of cutting conditions, you must first select the destination COND No. By
selecting a different COND No., you can easily switch between pre-defined cutting conditions for four types
of media.
Procedure
1. Press a function key (
,
,
, or
) to select a pre-defined set of cutting conditions of the
corresponding number.
2. The selected set of cutting conditions are loaded to the plotter and become the currently selected cutting
conditions.
To Next Page
Loading...
