GRAPHTEC FC4200-50 - Adjusting Sensor via Cross Pattern Plotting; Adjusting the Sensor by Printing a Cross Pattern

FC4200-UM-251-03-9370 68
SPECIFYING THE PEN CONDITIONS
10.3.4 Selecting the Cutting QUALITY
The QUALITY parameter is used to specify the acceleration rate during cutting or plotting.
Select the QUALITY setting while referring to the optimum QUALITY setting for both your pen type and
the currently loaded medium.
Setting Procedure
1. Press a function key from
F1
to
F4
to select the COND No. of the cutting conditions to be edited.
2. Press the
CONDITIONS key to display the menu below for specifying the cutting conditions.
FORCE
SPEED
OFFSET
QUALITY
F1 F3
F4
F2
12 COND1 09U 0
30 CHANGE PEN1 4
3. Press the
F4
(QUALITY) key to move the blinking cursor to the lower right position as shown in
the following figure.
FORCE
SPEED
OFFSET
QUALITY
F1 F3
F4
F2
12 COND1 09U 0
30 CHANGE PEN1 4
4. To change the QUALITY setting, press the or POSITION key to specify the QUALITY setting
in a range from 1 to 6. A lower value selects a slower acceleration rate which results in higher quality.
5. When the displayed conditions are satisfactory, press the
ENTER key. To exit this setting
operation without registering your new setting(s), press the NEXT PAGE key before pressing the
ENTER key.