10 – 4
The parameter values are as follows:
Baud rate : 19200, 9600, 4800, 2400, 1200, 600, 300
Data length : 7BIT (7bits), 8BIT (8bits)
Parity : N (none), E (even), O (odd)
Handshake : H (hardwire), X (X-on/X-off), E (Enq/Ack; selectable in HP-GL command mode only)
Select the appropriate values to match those of your application program.
(7) When the displayed settings are satisfactory, press the ENTER key to register your setting.
(8) Press the PAUSE key to return the plotter to READY status.
To Next Page
Loading...
