GRAPHTEC FC4200-50 - Selecting the Cutting QUALITY Parameter; Adjusting Cutting Quality Settings

4 – 5
(3) Press the
F2
(SPEED) key to move the blinking cursor to the lower left position as shown in the
following figure.
(4) To change the SPEED setting, press the or POSITION key. Permissible SPEED values are:
1 through 10, 15, 20, 25, 30, 35, 40, 45, 50, 55, 60, and 65.
(5) When the displayed conditions are satisfactory, press the ENTER key. To exit this setting opera-
tion without registering your new setting(s), press the NEXT PAGE key before pressing the
ENTER key.
4.3.4 Selecting the Cutting QUALITY
The QUALITY parameter is used to specify the acceleration rate during cutting or plotting.
Select the QUALITY setting while referring to the optimum QUALITY setting for both your pen type and the
currently loaded medium.
Setting Procedure
(1) Press a function key from
F1
to
F4
to select the COND No. of the cutting conditions to be edited.
(2) Press the CONDITIONS key to display the menu below for specifying the cutting conditions.
(3) Press the
F4
(QUALITY) key to move the blinking cursor to the lower right position as shown in
the following figure.
(4) To change the QUALITY setting, press the or POSITION key to specify the QUALITY setting
in a range from 1 to 6. A lower value selects a slower acceleration rate which results in higher quality.
(5) When the displayed conditions are satisfactory, press the ENTER key. To exit this setting opera-
tion without registering your new setting(s), press the NEXT PAGE key before pressing the
ENTER key.
FORCE
SPEED
OFFSET
QUALITY
F1 F3
F4
F2
12 COND1 09U 0
30 CHANGE PEN1 4
FORCE
SPEED
OFFSET
QUALITY
F1 F3
F4
F2
12 COND1 09U 0
30 CHANGE PEN1 4
FORCE
SPEED
OFFSET
QUALITY
F1 F3
F4
F2
12 COND1 09U 0
30 CHANGE PEN1 4