6 – 25
Registration mark pattern 1 Registration mark pattern 2
Origin
Origin
After the sensor reads the cross symbol, a cross symbol for use in adjustment is plotted using the pen
in Pen Holder 1 (see the figure below).
(6) After the sensor reads the cross symbol plotted for use in adjustment, the menu below appears.
(7) Press the
F2
(X=) or
F4
(Y=) key to move the blinking cursor to the value to be corrected.
To change the corrective value for sensor adjustment, use the and POSITION keys. (If no
correction is required, skip to Step (8)).
(8) When the displayed setting is satisfactory, press the ENTER key to register your setting.
(9) Press the PAUSE key to return the plotter to READY status.
6.11.3 Specifying the Registration MARK OFFSET
Unless the origin point has been moved to a new position, it is located at the lower left corner of the
effective cutting/plotting area. Use the MARK OFFSET function when you wish to move the origin of the
registration mark.
Setting Procedure
(1) Press the PAUSE key, then press the NEXT PAGE key until the menu below appears.
FORCE
SPEED
OFFSET
QUALITY
F1 F3
F4
F2
CURRENT VALUES
X= 0 Y= 0
FORCE
SPEED
OFFSET
QUALITY
F1 F3
F4
F2
MARK PEN U/D
CLEAR SELECT PEN
The 2nd cross plotted Value for X-axis
distance correction
Value for Y-axis
distance correction
To Next Page
Loading...
