9 – 9
9.3 Error Messages
9.3.1 General Error Messages
Solution
Lower the SPEED setting. Lower
the FORCE setting.
After removing the obstacle, turn
the plotter off then back on again.
After removing the obstacle, turn
the plotter off then back on again.
After removing the obstacle(s), turn
the plotter off then back on again.
* If this problem occurs frequently,
contact your sales representative
or nearest Graphtec vendor.
Error message
[X POSITION ALARM
POWER OFF THEN ON]
or
[Y POSITION ALARM
POWER OFF THEN ON]
• The beeper sounds.
• The PROMPT lamp lights.
Cause
The cutting conditions specified for
the medium to be cut are unrea-
sonable.
Something is obstructing the pen
carriage’s movement.
An external load was applied to the
pen carriage during operation.
Fragments of the cut medium have
entered into the plotter’s moving
parts and are impeding their move-
ment.
The table of acceleration rates is
faulty.
To Next Page
Loading...
