GRAPHTEC FC4200-50 - Image Orientation Control: Enabling the ROTATE Mode; Enabling the ROTATE Mode

6 – 4
Rotated origin point
Rotated coordinate axes
When ROTATE mode is ON
When ROTATE mode is OFF
Original origin
Y
X
Y
X
Original direction of coordinate axes
FORCE
SPEED
OFFSET
QUALITY
F1 F3
F4
F2
MARK PEN U/D
CLEAR SELECT PEN
FORCE
SPEED
OFFSET
QUALITY
F1 F3
F4
F2
INTERFACE FUNCTION
FILM PEN WIDTH
FORCE
SPEED
OFFSET
QUALITY
F1 F3
F4
F2
ROTATE MIRROR
THICK SORT
FORCE
SPEED
OFFSET
QUALITY
F1 F3
F4
F2
ROTATE
ON OFF
*
6.3 Enabling the ROTATE Mode to Rotate the Coordinate Axes
The ROTATE function selects the ON/OFF status of the ROTATE mode. Set the ROTATE mode to ON in
order to rotate the coordinate system of an image as shown in the example below.
Setting Procedure
(1) Press the PAUSE key, then press the NEXT PAGE key until the menu below appears.
(2) Press the NEXT PAGE key until the menu below appears.
(3) Press the
F3
(FUNCTION) key to display the menu below.
(4) Press the
F1
(ROTATE) key to display the menu below.