H3C S5100-SI

830 pages

To Next Page

To Next Page

To Previous Page

To Previous Page

Loading...

1-5

# Configure the access management IP address pool on GigabitEthernet 1/0/2.

[Sysname] interface GigabitEthernet 1/0/2

[Sysname-GigabitEthernet1/0/2] am ip-pool 202.10.20.25 26 202.10.20.55 11

# Add GigabitEthernet 1/0/2 to the port isolation group.

[Sysname-GigabitEthernet1/0/2] port isolate

[Sysname-GigabitEthernet1/0/2] quit

Table of Contents

About this Manual3
- Table of Contents3
- Obtaining Documentation5
- Related Documentation5
Documentation Feedback7
- 1 Obtaining the Documentation8
- 2 Correspondence between Documentation and Software9
  - Manual List9
  - Software Version9
- 3 Product Overview11
- 4 Networking Applications13
Login15
- 1 Logging in to an Ethernet Switch17
  - Introduction to the User Interface17
- 2 Logging in through the Console Port20
- 3 Logging in through Telnet33
- 4 Logging in Using a Modem44
- 151 CLI Configuration49
- 7 Logging in through NMS63
  - Introduction63
  - Connection Establishment Using NMS63
- 8 Configuring Source IP Address for Telnet Service Packets64
  - Overview64
  - Displaying Source IP Address Configuration65
- 9 User Control66
Configuration File Management73
- Configuration File Management74
  - Introduction to Configuration File74
  - Configuration Task List75
VLAN Overview/Vlan Configuration79
- 1 VLAN Overview80
- 2 VLAN Configuration90
Management VLAN Configuration101
- Introduction to Management VLAN102
- Management VLAN Configuration102
- Management VLAN Configuration103
- Displaying and Maintaining Management VLAN Configuration105
Voice VLAN Configuration106
- Voice VLAN Configuration107
- Voice VLAN Overview107
- Voice VLAN Configuration112
- Displaying and Maintaining Voice VLAN115
- Voice VLAN Configuration Example116
  - Voice VLAN Configuration Example (Automatic Mode)116
  - Voice VLAN Configuration Example (Manual Mode)117
Gvrp Configuration119
- GVRP Configuration120
- Introduction to GVRP120
- GVRP Configuration123
- Displaying and Maintaining GVRP125
- GVRP Configuration Example126
Port Basic Configuration130
- Combo Port Configuration131
- Ethernet Port Configuration131
- Port Basic Configuration131
- Configuring Port Auto-Negotiation Speed132
- Initially Configuring a Port132
- Limiting Traffic on Individual Ports133
- Duplicating the Configuration of a Port to Other Ports134
  - Link Aggregation135
- Enabling Flow Control on a Port134
- Configuring Loopback Detection for an Ethernet Port135
- Enabling Loopback Test136
- Enabling the System to Test Connected Cable136
- Configuring the Interval to Perform Statistical Analysis on Port Traffic137
- Disabling Up/Down Log Output on a Port137
- Configuring a Port Group138
- Displaying and Maintaining Basic Port Configuration139
Link Aggregation Configuration140
- Link Aggregation Configuration141
- Overview141
- Link Aggregation Classification142
- Aggregation Group Categories145
- Link Aggregation Configuration146
- Displaying and Maintaining Link Aggregation Configuration149
- Link Aggregation Configuration Example149
  - Ethernet Port Aggregation Configuration Example149
- Port Isolation152
Port Security Configuration/Port Binding Configuration156
- 1 Port Security Configuration157
- 2 Port Binding Configuration167
Dldp Configuration169
- DLDP Configuration170
- Overview170
- DLDP Fundamentals171
- DLDP Configuration177
- DLDP Configuration Example179
Mac Address Table Management181
- MAC Address Table Management182
- Overview182
- Configuring MAC Address Table Management185
- Displaying MAC Address Table Information188
  - Adding a Static Mac Address Entry Manually189
Mstp Configuration190
- MSTP Configuration192
- Overview192
- MSTP Configuration Task List206
- Configuring Root Bridge208
- Configuring Leaf Nodes220
- Performing Mcheck Operation224
- Configuring Guard Functions225
- Configuring Digest Snooping230
  - Introduction230
- Configuring Rapid Transition232
  - Introduction232
  - Configuring Rapid Transition234
- Configuring VLAN-VPN Tunnel235
  - Introduction235
- MSTP Maintenance Configuration236
- Displaying and Maintaining MSTP237
- Enabling Trap Messages Conforming to 802.1D Standard237
- MSTP Configuration Example238
- VLAN-VPN Tunnel Configuration Example240
Table of Contents242
- 802.1X Configuration244
- 2 Quick EAD Deployment Configuration267
- 3 HABP Configuration272
- 4 System-Guard Configuration274
  - System-Guard Overview274
Aaa Overview/Aaa Configuration276
- 1 Aaa Overview278
  - Introduction to AAA278
  - Introduction to AAA Services279
    - Introduction to RADIUS279
    - Introduction to HWTACACS284
- 2 AAA Configuration287
  - AAA Configuration Task List287
  - MAC Address Authentication294
- 3 EAD Configuration318
Mac Address Authentication Configuration322
- MAC Address Authentication Configuration323
- MAC Address Authentication Overview323
  - Performing MAC Address Authentication on a RADIUS Server323
  - Performing MAC Address Authentication Locally323
- Configuring Basic MAC Address Authentication Functions324
- Related Concepts324
  - Mac Address Authentication Timers324
  - Quiet MAC Address324
- MAC Address Authentication Enhanced Function Configuration326
- Displaying and Maintaining MAC Address Authentication Configuration329
- MAC Address Authentication Configuration Examples329
IP Addressing Configuration/Ip Performance Optimization Configuration331
- 1 IP Addressing Configuration332
  - IP Addressing Overview332
  - Dhcp334
- 2 IP Performance Optimization Configuration338
Table of Contents342
- Default Chapter343
- 2 DHCP Relay Agent Configuration347
- 3 DHCP Snooping Configuration355
- 4 DHCP/BOOTP Client Configuration368
Acl Configuration371
- Acl Configuration372
- ACL Matching Order372
- Acl Overview372
  - Ways to Apply an ACL on a Switch373
- ACL Configuration374
- ACL Assignment379
- Displaying ACL Configuration383
- Example for Upper-Layer Software Referencing Acls383
  - Example for Controlling Telnet Login Users by Source IP383
  - Example for Controlling Web Login Users by Source IP384
- Example for Applying Acls to Hardware384
Qos Configuration388
- 1 Qos Configuration390
- 2 Qos Profile Configuration441
Mirroring Configuration447
- Mirroring Configuration448
- Mirroring Overview448
- Qos-Qos Profile451
Arp Configuration463
- ARP Configuration464
- Introduction to ARP464
- Configuring ARP468
  - Configuring ARP Basic Functions468
  - Configuring ARP Attack Detection469
- Configuring Gratuitous ARP470
- Displaying and Debugging ARP470
- ARP Configuration Examples471
  - ARP Basic Configuration Example471
  - ARP Attack Detection Configuration Example471
Stack/Cluster473
- 1 Stack474
- 2 Cluster480
Snmp Configuration/Rmon Configuration507
- 1 Snmp Configuration508
- 2 RMON Configuration516
Igmp Snooping Configuration/Common Multicast Configuration521
- Default Chapter523
- 2 IGMP Snooping Configuration535
- 3 Common Multicast Configuration555
  - Configuring a Multicast MAC Address Entry555
  - Displaying Common Multicast Configuration556
    - Configuring Dropping Unknown Multicast Packets556
Ntp Configuration557
- Introduction to NTP558
- Ntp Configuration558
- Configuring NTP Implementation Modes563
- NTP Configuration Task List563
- Configuring Access Control Right567
  - Configuration Prerequisites568
  - Configuration Procedure568
- Configuring NTP Authentication568
  - Configuration Prerequisites569
- Configuring Optional NTP Parameters571
  - Configuring an Interface on the Local Switch to Send Ntp Messages571
  - Configuring the Number of Dynamic Sessions Allowed on the Local Switch571
- Displaying NTP Configuration572
  - Disabling an Interface from Receiving Ntp Messages572
- Configuration Examples573
Ssh Configuration581
- Ssh Configuration582
- SSH Overview582
- SSH Server and Client585
- Configuring the SSH Server586
- Configuring the SSH Client595
- Comparison of SSH Commands with the same Functions604
- Displaying and Maintaining SSH Configuration604
- SSH Configuration Examples605
File System Management Configuration628
- File System Configuration629
- File System Management Configuration629
- File Attribute Configuration633
  - Introduction to File Attributes633
  - Configuring File Attributes634
Ftp and Sftp Configuration/Tftp Configuration636
- 1 Ftp and Sftp Configuration637
- 2 TFTP Configuration657
  - Introduction to Tftp657
    - TFTP Configuration: a Switch Operating as a TFTP Client658
    - TFTP Configuration Example659
Information Center661
- Information Center662
  - System Information Format665
- Information Center Configuration668
- Displaying and Maintaining Information Center675
- Information Center Configuration Examples676
Table of Contents681
- 1 Boot Rom and Host Software Loading682
- 2 Basic System Configuration and Debugging697
  - Displaying the System Status698
  - Debugging the System698
- 3 Network Connectivity Test700
  - Ping700
  - Tracert700
- 4 Device Management702
Vlan-Vpn Configuration/Selective Qinq Configuration709
- 1 VLAN-VPN Configuration710
- 2 Selective Qinq Configuration717
Hwping Configuration723
- Hwping Configuration724
- Hwping Overview724
- Hwping Configuration Examples738
Smart Link Configuration/Monitor Link Configuration762
- 1 Smart Link Configuration763
- 2 Monitor Link Configuration771
Ipv6 Configuration/Ipv6 Application Configuration777
- 1 Ipv6 Configuration778
- 2 Ipv6 Application Configuration798
Poe Configuration/Poe Profile Configuration804
- 1 Poe Configuration805
  - Poe Overview805
  - Poe Configuration Example811
- 2 Poe Profile Configuration813

Related product manuals

Preview: H3C S5130S Series

H3C S5130S Series

Preview: H3C S5130S-10P-EI

H3C S5130S-10P-EI

Preview: H3C S5120-EI Series

H3C S5120-EI Series

Preview: H3C S5120-SI Series

H3C S5120-SI Series

Preview: H3C S5170-EI Series

H3C S5170-EI Series

Preview: H3C S5130S-EI series

H3C S5130S-EI series

Preview: H3C S5500-EI

Preview: H3C S5820V2-52Q

H3C S5820V2-52Q

Preview: H3C S5560-EI series

H3C S5560-EI series

Preview: H3C S5560X-HI Series

H3C S5560X-HI Series

Preview: H3C S5560S-EI Series

H3C S5560S-EI Series

Preview: H3C S5560S-SI Series

H3C S5560S-SI Series