H3C S5500-EI - Page 323

304
[SwitchB-isp-domian2] quit
[SwitchB] domain default enable domain2
# Globally enable 802.1X and then enable it on GigabitEthernet 1/0/2 and GigabitEthernet
1/0/3.
[SwitchB] dot1x
[SwitchB] interface gigabitethernet 1/0/2
[SwitchB-GigabitEthernet1/0/2] dot1x
[SwitchB-GigabitEthernet1/0/2] quit
[SwitchB] interface gigabitethernet 1/0/3
[SwitchB-GigabitEthernet1/0/3] dot1x
[SwitchB-GigabitEthernet1/0/3] quit
4. Configure RADIUS server:
On the RADIUS server, configure the parameters related to Switch A and Switch B. For more
information, see the configuration guide of the RADIUS server.
Verifying the configuration
After the configurations, the two multicast sources and hosts initiate 802.1X authentication. After passing
the authentication, Source 1 sends multicast flows to FF1E::101 and Source 2 sends multicast flows to
FF1E::102; Host A sends report messages to join IPv6 multicast groups FF1E::101 and FF1E::102. Use the
display mld-snooping group command to display information about MLD snooping groups. For
example:
# Display information about MLD snooping groups in VLAN 104 on Switch B.
[SwitchB] display mld-snooping group vlan 104 verbose
Total 1 IP Group(s).
Total 1 IP Source(s).
Total 1 MAC Group(s).
Port flags: D-Dynamic port, S-Static port, C-Copy port, P-PIM port
Subvlan flags: R-Real VLAN, C-Copy VLAN
Vlan(id):104.
Total 1 IP Group(s).
Total 1 IP Source(s).
Total 1 MAC Group(s).
Router port(s):total 1 port(s).
GE1/0/1 (D) ( 00:01:30 )
IP group(s):the following ip group(s) match to one mac group.
IP group address:FF1E::101
(::, FF1E::101):
Attribute: Host Port
Host port(s):total 1 port(s).
GE1/0/3 (D) ( 00:04:10 )
MAC group(s):
MAC group address:3333-0000-0101
Host port(s):total 1 port(s).
GE1/0/3