EasyManua.ls Logo

H3C S5500-EI - Page 376

H3C S5500-EI
490 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
357
Task Command Remarks
Display the information of the MLD
routing table.
display mld routing-table
[ ipv6-source-address
[ prefix-length ] |
ipv6-group-address [ prefix-length ]
| flags { act | suc } ] * [ | { begin |
exclude | include }
regular-expression ]
Available in any view.
Display MLD SSM mappings.
display mld ssm-mapping
ipv6-group-address [ | { begin |
exclude | include }
regular-expression ]
Available in any view.
Display the IPv6 multicast group
information created based on the
configured MLD SSM mappings.
display mld ssm-mapping group
[ ipv6-group-address | interface
interface-type interface-number ]
[ verbose ] [ | { begin | exclude |
include } regular-expression ]
Available in any view.
Display information about the hosts
that join based on the MLD SSM
mappings on an interface.
display mld ssm-mapping host
interface interface-type
interface-number group
ipv6-group-address source
ipv6-source-address [ | { begin |
exclude | include }
regular-expression ]
Available in any view.
Remove the dynamic group entries
of a specified MLD group or all
MLD groups.
reset mld group { all | interface
interface-type interface-number
{ all | ipv6-group-address
[ prefix-length ]
[ ipv6-source-address
[ prefix-length ] ] } }
Available in user view.
This command cannot remove
dynamic MLD group entries.
Remove the dynamic Layer 2 port
entries of a specified MLD group or
all MLD groups.
reset mld group port-info { all |
ipv6-group-address } [ vlan
vlan-id ]
Available in user view.
This command cannot remove the
Layer 2 port entries of MLD groups.
Clear MLD SSM mappings.
reset mld ssm-mapping group { all
| interface interface-type
interface-number { all |
ipv6-group-address [ prefix-length ]
[ ipv6-source-address
[ prefix-length ] ] } }
Available in user view.
The display mld host interface command can display information about the hosts tracked by MLD on
Layer 3 interfaces other than VLAN interfaces.
The display mld ssm-mapping host interface command can display information about the hosts that join
the group based on MLD SSM mappings on Layer 3 interfaces other than VLAN interfaces.

Table of Contents

Related product manuals