Appendix A Legacy Hardware Platforms
© 2017 Harmonic Inc. All rights reserved. 327 Harmonic MediaGrid Release 4.1
ContentBridge 2010E
Flashing Amber Indicates a problem with the power supply.
CAUTION: When correcting a power supply mismatch, replace only the power
supply with the flashing indicator. Swapping the opposite power supply to make a
matched pair can result in an error condition and unexpected system shutdown.
To change from a High Output configuration to a Low Output configuration or vice
versa, you must power down the system.
CAUTION: AC power supplies support both 220 V and 110 V input voltages.
When two identical power supplies receive different input voltages, they can
output different wattages, and trigger a mismatch.
CAUTION: If two power supplies are used, they must be of the same type and
have the same maximum output power.
Flashing Green
When hot-adding a power supply, this indicates that the power supply is mismatched
with the other power supply (in terms of efficiency, feature set, health status, and
supported voltage). Replace the power supply that has the flashing indicator with a
power supply that matches the capacity of the other installed power supply.
Indicator Pattern Condition
To Next Page
Loading...
