Harmonic ProView PVR 6000 Series - Page 79

PVR 6000 Series
Professional Integrated Receiver Decoders
Page 4-9
LNB L.O. TYPE
The LNB L.O. type parameter defines the LNB oscillator type in use. Two
standards are generally used: ‘Universal’ and ‘Wide Band’.
In addition, the oscillator value can be manually configured.
The LNB L.O. type can be acquired from satellite transponder information. Most
satellites use the ‘Universal’ type of L.O. unless otherwise specified.
NOTE
Manual configuration of the oscillator frequency is rarely used and is intended
only for advanced users.
LNB L.O. Type
1 UNIVERSAL (9.75,10.6)
2{ WIDE BAND (9.75,10.75)
3{ Ku BAND
4{ C BAND
5{ DiSEqC (9.75, 10.6)
Available LNB L.O. types are:
• UNIVERSAL (9.75,10.6) – Defines LNB universal L.O. type
• WIDE BAND (9.75, 10.75) – Defines LNB wide band L.O. type
• Ku-BAND – Defines Ku-Band LNB L.O. type
• C-BAND – Defines C-Band LNB L.O. type
• DiSEqC (9.75, 10.75)
NOTE
When selecting the Ku-Band or the C-Band, you must manually set the L.O.
frequency (see the following Section in this chapter).