Introduction
Quantum
X
I3031-14.0 HBM: public 21
S MX238B Precision full bridge amplifier
The module has 2 full bridge SG inputs with an accu
racy of 25 ppm.
S MX460B Digital module (counter, frequency, timer)
The module has 4 individually configurable inputs for
connecting HBM torque measurement shafts (T12,
T40, T10), rotational speed sensors, crankshaft sen
sors with gap (TDC sensor), pulse width modulated
signals - PWM
S MX471B CAN module
The module has 4 CAN bus nodes that can be con
figured for receiving and sending messages. The
module supports the CCP and xCP-on-CAN protocols
on up to 2 channels.
S MX1601B Analog amplifier (standardized voltage /
current, IEPE)
The module has 16 individually configurable inputs for
standardized voltage or current measurement or for
connecting current-fed piezoelectric transducers
(IEPE / ICP(R) ).
S MX1615B SG bridge amplifier
The module has 16 individually configurable inputs for
SGs in quarter, half and full bridge circuits. Bridge
excitation voltage DC or carrier frequency (1200 Hz).
S MX1609KB Thermocouple amplifier
The module has 16 inputs for type K thermocouples.
S MX1609TB Thermocouple amplifier
The module has 16 inputs for type K thermocouples.
S MX809B Thermo measurement module
The module has 8 inputs for measurement of tempe
ratures with thermocouples or electrical cell voltages
up to 5 V at a potential up to 1000 V in energy storage
systems. General measurement categories: 600 V
CAT II, 300 V CAT III.
The module and entire production have been certified
To Next Page
Loading...
