HeMaTech 3925-0050 - Page 120

In semi-automatic operation Signal Exchange with Machine Control
EN 3925-0060 V207-00 MANUAL R03.doc
HeMaTech Prüftechnik
120
ja
Prüfgerät
Ein
Setzen Ausgang
Betriebsbereit
Ausgang BETRIEBSBEREIT
X20/1
Eingänge PROGRAMMNUMMER (Binär)
X21/10 ... 17
Eingang START
X21/2
Start ?
nein
Reset Ausgang
Prüfergegnis
Ablauf der
Prüfung
Füllen
Ausgleichen ...
Setzen Ausgang
Prüfergebnis
Ausgang PRÜFERGEBNIS
X20/4 .. 6
In minimal operation
The signals Automatic, Machine ready and Ready for test are not used in this opera-
tion mode.
The program numbers are read in at the start as binary code.
When the tester is switched on, the output Ready for operation is set.
Now the measurement can be triggered with the signal Start (pulse of approx. 1 se-
cond), the test result is deleted.
Once the measurement is finished, the test result (leak tight, Leak or rework) is submit-
ted and the output Ready for operation is set.
Flow chart for minimal operation
no
yes
Input START
X21/2
Output TEST RESULT
X20/4 .. 6
Set output
Ready for
operation
Reset output
Test result
Set output
Test result
Test sequence
Filling
Equalizing ...
Output READY FOR OPERATION
X20/1
Inputs PROGRAM NUMBER (binär)
X21/10 … 17
Tester
ON