Hi-Target HTS-420R - Page 50

Total Station Manual
- 49 -
○
4 After finishing setting
up the fixpoint, the height
of fixpoint is displayed in
the screen and press [F1]
（ALL）or [F2]（DIST）+[F3]
（ REC ） to start to
measure and calculate,
the height of station is
calculated.
[F1]
or
[F2]
+
[F3]
ALL
[Height Transfer] 1
DIST REC ↓
偏置模式 :
Select target and meas.!
Pt ： Pt.1
： m
T.H. ： 1.200 m
Z ： 2.500 m
1
○
5 In the interface of
[Height Transfer Result],
pressing [PAGE] to switch
the display of result
information.
Press [F1]（Add PT） to add
a new point and to start a
new measurement.
Press [F3]（Back） to back
to measure the current
point again.
Press [F4]（OK）to enter the
interface of [Set STA HO].
[PAGE]
Add PT
[Height Transfer Result] 1/2
Back OK
偏置模式 :
Station ： STN
Z0/H0 ： 0.781 m
PT NUM. ： 1
Correc. ： 0.000 m
Add PT
[Height Transfer Result] 2/2
Back OK
偏置模式 :
Station ： STN
Y0/E0 ： 0.081 m
X0/N0 ： 0.081 m
PT NUM ： 1
Z0/H0 ： 0.081 m
Errors ： 0.000 m
○
6 Pressing [F1] to back to
the interface of [Height
Transfer Result].
Press [F2] to set the height
of staton to the old value
Press [F4] to set the height
of station to the new value
which calculated after
Height Transfer.
Press [F3] to set the height
of station to the average of
the old value and new
vlaue
Back
[Set STA H0]
OLD AVG NEW
偏置模式 :
Station ： STN
Old H0 ： 0.000 m
New H0 ： 0.781 m
ΔH0 ： 0.781 m