Hi-Target HTS-420R - Page 87

Total Station Manual
- 86 -
○
4 Aim at the prism. Press
[F2](DIST) to start measuring
and calculate the differences
between measured point and
stakeout point.
[F2]
New DIST REC Back
[Polar Stakeout]
Pt. :
Hz : ←
: ↑
P001
39°15′12″
-6.132 m
○
5 Turn the instrument
telescope to make the △Hz
equal 0°00’00” and command
the staff to move the prism at
the same time.
△Hz is positive: The stakeout
point is in the left side of
measured point. Move the
prism to left.
△ Hz is negative: The
stakeout point is in the right
side of measured point.
Move the prism to right.
New DIST REC Back
[Polar Stakeout]
Pt. :
Hz : ←
: ↑
P001
39°15′12″
-6.132 m
○
6 Set and aim at the prism
in the direction of △Hz =
0°00’00”. Press [F2](DIST) to
start measuring and calculate
the differences between
measured point and stakeout
point.
△ is positive: The
stakeout point is is closer to
the station. Move the prism
close to the station.
△ is negative: The
stakeout point is is farther to
the station. Move the prism
far away the station.
[F2]
New DIST REC Back
[Polar Stakeout]
Pt. :
Hz : *
: ↑
P001
0°00′00″
-3.152 m