10.8.1 Mulcast Discovery
Go to Conguraon → Network → Network Sengs → TCP/IP to enable this funcon.
Check the Enable Mulcast Discovery, and then the online ne
twork camera can be automacally
detected by client soware via private mulcast protocol in the LAN.
10.9 RTSP
RTSP (Real Time Streaming Protocol) is an applicaon-layer controlling protocol for streaming
media.
St
eps
1.
Go to Conguraon → Network → Network Service → RTSP .
2.
Enter Port.
3.
Set Mulcast parameters.
Stream Type
The stream type as the mulcast source.
Video Port
The video port of the selected stream.
Audio Port
The audio port of the selected stream.
4.
Set RTSP
Authencaon.
Authencaon
Digest and digest/basic are supported, which means authencaon informaon is needed
when R
TSP request is sent to the device. If you select digest/basic, it means the device
supports digest or basic authencaon. If you select digest, the device only supports digest
authencaon.
Digest Algorithm
MD5, SHA256 and MD5/SHA256 encr
ypted algorithm in RTSP authencaon. If you enable
the digest algorithm except for MD5, the third-party plaorm might not be able to log in to
the device or enable live view because of compability. The encrypted algorithm with high
s
trength is recommended.
5.
Click Save.
10.10 Set SRTP
The Secure Real-me Transport Protocol (SRTP) is a Real-me Transport Protocol (RTP) internet
protocol, intended to provide encrypon, message authencaon and integrity, and replay aack
protecon to the RTP data in both unicast and mulcast applicaons.
TandemVu PTZ Camera User Manual
88
To Next Page
Loading...
Need help?
General
