HIKVISION DS-2SE4C425MWG-E/26(F0) User Manual

Custom a name for the alarm output.
2.
Click Manual Alarm to enable manual alarm output.
3.
Oponal: Click Clear Alarm to disable manual alarm output.
9.2.2 FTP/NAS/Memory Card Uploading
If you have enabled and congured the FTP/NAS/memory card uploading, the device sends the
alarm informaon to the FTP server, network aached storage and memory card when an alarm is
triggered.
Refer to Set FTP to set the FTP server.
Refer to Set NAS for NAS conguraon.
Refer to Set New or Unencrypted Memory Card for memory card storage conguraon.
9.2.3 Send Email
Check Send Email, and the device sends an email to the designated addresses with alarm
informaon when an alarm event is detected.
F
or email sengs, refer to
Set Email .
Set Email
When the email is congured and Send Email is enabled as a link
age method, the device sends an
email nocaon to all designated receivers if an alarm event is detected.
Before You Start
Set the DNS server before using the Email funcon. Go to Conguraon → Ne
twork → Basic
Sengs → TCP/IP for DNS sengs.
Steps
1.
Go t
o email sengs page: Conguraon → Network → Advanced Sengs → Email .
2.
Set email parameters.
1) Input the sender's email informaon, including the Sender's Address, SMTP Server, and
SMTP Port.
2) Oponal: If y
our email server requires authencaon, check Authencaon and input your
user name and password to log in to the server.
3) Set the E-mail Encrypon.
●
When you select SSL or TLS, and disable STARTTLS, emails are sent aer encrypted by SSL or
TLS. The SMTP port should be set as 465.
●
When you select SSL or TLS and Enable STARTTLS, emails are sent aer encrypted by
S
TARTTLS, and the SMTP port should be set as 25.
TandemVu PTZ Camera User Manual
75

HIKVISION DS-2SE4C425MWG-E/26(F0) Specifications

General

Brand	HIKVISION
Model	DS-2SE4C425MWG-E/26(F0)
Category	Security Camera
Language	English