HIKVISION DS-2SE4C425MWG-E/26(F0) - 11.13.4 Set QoS

Search Security Audit Logs
You can search and analyze the security log les of the device so as to nd out the illegal intrusion
and troubleshoot the security events.
Steps
Note
This funcon is only supported by certain camera models.
1.
Go t
o Maintenance and Security → Maintenance → Security Audit Log .
2.
Select log types, Start Time, and End Time.
3.
Click Search.
The log les that match the search condions will be displayed on the Log List.
4.
Oponal: Click Export to save the log les to your computer.
Set Log Server
The log server should support syslog (RFC 3164) over TLS.
Before You Start
●
Install client and CA cercates before
conguraon. Refer to
Cercate Management f
or
detailed informaon.
●
Select cercates according to the requirement of the log server. If two-way authencaon is
required, select the CA cercate and the client cercate. If one-way authencaon is
required, select the CA cercate
only.
Steps
1.
Click Advanced Conguraon.
2.
Check Enable Log Upload Server.
3.
Oponal: Check Enable Encr
ypted Transmission if you want the log data to be encrypted.
4.
Input Log Server IP and Log Server Port.
5.
Oponal: Click Test to test the sengs.
6.
Oponal: Select a client cercate.
7.
Select a CA
cercate to the device.
8.
Click Save.
11.13.4 Set QoS
QoS (Quality of Service) can help improve the network delay and network congeson by seng
the priority of data sending.
TandemVu PTZ Camera User Manual
98