HIKVISION DS-2SE4C425MWG-E/26(F0) - 8.1.2 Set Video Tampering Alarm

Figure 8-1 Set Rules
4.
Click to clear all the areas.
5.
Click Sa
ve.
6.
Oponal: R
epeat above steps to set mulple areas.
8.1.2 Set Video Tampering Alarm
When the congured area is covered and cannot be monitored normally, the alarm is triggered and
the device takes certain alarm response acons.
Steps
1.
Go t
o Conguraon → Event → Event and Detecon → Video Tampering .
2.
Select the channel number.
3.
Check Enable.
4.
Set the Sensivity. The higher the value is, the easier to detect the area covering.
5.
Click
and drag the mouse in the live view to draw the area.
TandemVu PTZ Camera User Manual
61