HIKVISION DS-2SE4C425MWG-E/26(F0) - 4.3.1 Set One-Touch Patrol; 4.4 Set Pattern Scan

It is the duraon staying on one patrol point.
Delete the presets in patrol.
Adjust the preset order.
Note
A patrol can be congured with 32 presets at most, and 2 presets at least.
4.
Click OK t
o nish a patrol seng.
5.
Repeat the steps above to congure mulple patrols.
6.
Operate patrols.
Call the patrol.
Stop patroling.
Delete the patrol.
Note
You can delete all patrols in Conguraon → P
TZ → Clear Cong . Check Clear All Patrols, and
click Save.
4.3.1 Set One-Touch Patrol
The device automacally adds presets to one patrol path and starts patrol scan.
St
eps
1.
Set two or more presets among preset No.1 to preset No.32. For seng presets, refer to
Set
Preset .
The de
vice will automacally add presets to patrol path No.8.
2.
Choose one of the following methods to enable the funcon.
-
Click
.
-
Call pa
trol path No.8.
-
Select and call preset No.45.
4.4 Set Paern Scan
The device can move as the recorded
paern.
Steps
1.
Click
to show the PTZ control panel, and click .
2.
Select one
paern scan path that needs to be set.
3.
Click
to start recording
paern scan.
4.
Click PTZ control buons as demands.
TandemVu PTZ Camera User Manual
20