HIKVISION DS-2SE4C425MWG-E/26(F0) User Manual

4.8 Set Scheduled Tasks
You can set the device to perform a certain task during a certain period.
Steps
1.
Go to Conguraon → PTZ → Scheduled Tasks .
2.
Check Enable.
3.
Select the task type and set the period. For seng the period, refer to Set Arming Schedule .
4.
Repeat step 3 to set more than one scheduled tasks.
5.
Set Park Time. During the set task period, if you operate the device manually, the scheduled task
will be suspended. When the manual operaon is over, the device will connue to perform the
scheduled task aer the set park me.
6.
Click Save.
Note
If you want to clear all scheduled tasks, go to Conguraon → P
TZ → Clear Cong , check Clear
All Scheduled Tasks, and click Save.
4.9 Set Power
O Memory
This funcon can resume the previous PTZ status of device aer it restarng from a power-o.
Steps
1.
Go to Conguraon → P
TZ → Basic Sengs .
2.
Select Resume Time Point. When the device stays at one posion for the set resume me point
or more, the posion is saved as a memory point. The device returns to the last memory point
when it restarts.
3.
Click Save.
4.10 Set PTZ Priority
The funcon can set the PTZ priority of dierent signals.
St
eps
1.
Go to Conguraon → PTZ → Priorize PTZ .
2.
Set the priority signal and delayed me.
Network
The ne
twork signal controls the device with priority.
RS-485
The RS-485 signal controls the device with priority.
Delay
TandemVu PTZ Camera User Manual
23

HIKVISION DS-2SE4C425MWG-E/26(F0) Specifications

General

Brand	HIKVISION
Model	DS-2SE4C425MWG-E/26(F0)
Category	Security Camera
Language	English