HIKVISION DS-2SE4C425MWG-E/26(F0) - 8.1.3 Set Alarm Input

Figure 8-2 Set Video Tampering Area
6.
Oponal: Click to delete all the drawn areas.
7.
R
efer to
Set Arming Schedule f
or seng scheduled me. Refer to
Linkage Method Sengs for
seng linkage method.
8.
Click Sa
ve.
8.1.3 Set Alarm Input
Alarm signal from the external device triggers the corresponding acons of the current device.
Before You Start
Note
This funcon is only supported by certain models.
Make sure the external alarm device is connected. See Quick St
art Guide for cable connecon.
TandemVu PTZ Camera User Manual
62