HIKVISION DS-2SE4C425MWG-E/26(F0) - 10.3 SNMP

Figure 10-1 Port Mapping on Router
Note
The port of the network camera cannot conict with other ports. For example, some web
manag
ement port of the router is 80. Change the camera port if it is the same as the management
port.
10.3 SNMP
You can set the SNMP network management protocol to get the alarm event and excepon
messages in network transmission.
Be
fore You Start
Before seng the SNMP, you should download the SNMP soware and manage to receive the
de
vice informaon via SNMP port.
Steps
1.
Go to Conguraon → Network → Network Sengs → SNMP .
2.
Check Enable SNMPv1, Enable SNMP v2c or Enable SNMPv3.
Note
The SNMP version you select should be the same as that of the SNMP soware.
TandemVu PTZ Camera User Manual
82