HIKVISION DS-2SE4C425MWG-E/26(F0) User Manual

9.2.1 Trigger Alarm Output
If the device has been connected to an alarm output device, and the alarm output No. has been
congured, the device sends alarm
informaon to the connected alarm output device when an
alarm is triggered.
Steps
1.
Go to Conguraon → E
vent → Alarm Seng → Alarm Output .
2.
Set alarm output parameters.
Automac Alarm For the informaon about the conguraon, see Automac Alarm .
Manual Alarm For the informaon about the conguraon, see
Manual Alarm .
Automac Alarm
Set the
automac alarm parameters, then the device triggers an alarm output automacally in the
set arming schedule.
Before You Start
Make sure the alarm output device is connected to the device.
Steps
1.
Select the Alarm Output No. according to the alarm interface connected to the external alarm
device. Click
to set alarm parameters.
Alarm Name
Cus
tom a name for the alarm output.
Delay
It refers to the me
duraon that the alarm output remains aer an alarm occurs.
2.
Set the alarming schedule. For the informaon about the sengs, see
Set Arming Schedule .
3.
Oponal: Click Cop
y to… to copy the parameters to other alarm output channels.
4.
Click Save.
Manual Alarm
You can trigger an alarm output manually.
Before You Start
Make sure the alarm output device is connected to the device.
Steps
1.
Select the Alarm Output No. according to the alarm interface connected to the external alarm
device. Click
to set alarm parameters.
Alarm Name
TandemVu PTZ Camera User Manual
74

HIKVISION DS-2SE4C425MWG-E/26(F0) Specifications

General

Brand	HIKVISION
Model	DS-2SE4C425MWG-E/26(F0)
Category	Security Camera
Language	English