Input IPv6 Address, IPv6 Subnet, IPv6 Default Gateway. Consult the network administrator for
required informaon.
MTU
It stands for maximum transmission unit. It is the size of the largest protocol data unit that can
be communicated in a single network layer transacon.
The valid value range of MTU is 1280 to 1500.
DNS
It stands for domain name server. It is required if you need to visit the device with domain
name. And it is also required for some applicaons (e.g., sending email). Set Preferred DNS
Server and Alternate DNS server properly if needed.
Domain Name Sengs
Check Enable Dynamic Domain Name and input Register Domain Name. The device is
registered under the register domain name for easier management within the local area
network.
Note
DHCP should be enabled f
or the dynamic domain name to take eect.
10.2 Port Mapping
By
seng port mapping, you can access devices through the specied port.
Steps
1.
Go to Conguraon → Ne
twork → Network Service → NAT .
2.
Select the port mapping mode.
Auto Port Mapping Refer to
Set Auto Port Mapping f
or detailed informaon.
Manual Port Mapping Refer to
Set Manual Port Mapping f
or detailed informaon.
3.
Click Save.
10.2.1 Set Auto Port Mapping
Steps
1.
Check Enable UPnP™, and choose a friendly name for the camera, or you can use the default
name.
2.
Select the port mapping mode to Auto.
3.
Click Save.
Note
UPnP™
funcon on the router should be enabled at the same me.
TandemVu PTZ Camera User Manual
80
To Next Page
Loading...
Need help?
General
