HIKVISION DS-2SE4C425MWG-E/26(F0) User Manual

And you also need to use the dierent version according to the security level required. SNMP v1
is not secure and SNMP v2 requires password for access. And SNMP v3 provides encrypon and
if you use the third version, HTTPS protocol must be enabled.
3.
Congure
the SNMP sengs.
4.
Click Sa
ve.
10.4 Access to Device via Domain Name
You can use the Dynamic DNS (DDNS) for network access. The dynamic IP address of the device can
be mapped to a domain name resoluon server to realize the network access via domain name.
Before You Start
Registraon on the DDNS server is required before conguring the DDNS sengs of the device.
Steps
1.
Refer to TCP/IP to set DNS parameters.
2.
Go to the DDNS sengs page: Conguraon → Network → Network Sengs → DDNS .
3.
Check Enable and select DDNS Type.
DynDNS
Dynamic DNS server is used for domain name resoluon.
NO-IP
NO-IP ser
ver is used for domain name resoluon.
4.
Input the domain name informaon, and click Sa
ve.
5.
Check the device ports and complete port mapping. Refer to
Port Mapping f
or port mapping
sengs.
6.
Access the device.
By Browsers Enter the domain name in the browser address bar to access the device.
By Client Soware Add domain name to the client soware. Refer to the client manual for
specic adding methods.
10.5 Access to Device via PPPoE Dial Up
Connecon
This device supports the PPPoE auto dial-up funcon. The device gets a public IP address by ADSL
dial-up aer the device is connected to a modem. You need to congure the PPPoE parameters of
the device.
Steps
1.
Go to Conguraon → Network → Network Sengs → PPPoE .
2.
Check Enable.
3.
Set the PPPoE parameters.
Dynamic IP
TandemVu PTZ Camera User Manual
83

HIKVISION DS-2SE4C425MWG-E/26(F0) Specifications

General

Brand	HIKVISION
Model	DS-2SE4C425MWG-E/26(F0)
Category	Security Camera
Language	English