Routing
136
6.2
Configuring Router Interfaces
RM Web
Release
6.0
07/2010
Configuring the port-based router interface
Double-click on a cell in the “IP Address” column and enter the IP
address for this router interface.
Double-click on a cell in the “Netmask” column and enter the netmask
for this router interface.
Click once on a cell in the “Routing” column to switch on the routing
function for this router interface.
Click once on a cell in the “Proxy ARP” column to switch on the proxy
ARP function for this router interface.
Click once on a cell in the “Netdirected Broadcasts” column to switch
on the Netdirected Broadcasts function for this router interface.
Setting up a VLAN-based router interface
Click on the “Wizard” on the bottom right.
In the Wizard window,
– select a row in the table to configure an existing VLAN, or
– enter a VLAN ID for a new VLAN to be configured.
Click on “Continue”.
In the next Wizard window, enter the name of your choice under
“VLAN Name”.
In the “Member” column select the ports you wish to assign to the
VLAN.
Parameter Meaning
Module Module of the Switch on which the port is located. The Switch uses the
virtual module 9 for a VLAN-based router interface.
Port Port to which this entry applies.
Type Type of the router interface:
– Ethernet: physical port
– VLAN: VLAN-based router interface
VLAN ID VLAN ID of the VLAN-based router interface.
IP address IP address for this router interface.
Netmask Netmask for this router interface
Routing Switches the routing function on and off for this router interface.
Proxy ARP Switches the proxy ARP function on and off for this router interface.
Netdirected
Broadcasts
Switches the Netdirected Broadcasts function on and off for this router
interface.
Table 50: Router interface table
To Next Page
Loading...
Need help?
General
