Routing
RM Web L3E
Release
6.0
07/2010
6.2
Configuring Router Interfaces
137
“Untagged”: In this column you select the ports that you want to be
members of the VLAN and that will send data packets without a tag.
“Port VLAN ID”: Double-click on a cell in this column in order to change
the port VLAN ID. A tag with this port VLAN ID is added to data packets
which this port receives without a tag.
Click on “Continue”.
In the “Primary IP Address” frame you enter the IP address of this
router interface and the related netmask.
The “Secondary Addresses/Multinetting” frame enables you to assign
additional IP addresses to this router interface. Enter the IP address
and the netmask.
Click on “Add” to transfer the entry to the table.
Select a row in the table to delete it from the table using “Remove”.
Click on “Finished” to transfer the configured VLAN-based router
interface to the router interface table.
You then have the option of configuring additional parameters in the table
for the VLAN-based router interface, like with the configuration of port-
based router interfaces.
Click once on a cell in the “Routing” column to switch the routing
function for this router interface on or off.
Click once on a cell in the “Proxy ARP” column to switch on the proxy
ARP function for this router interface.
Click once on a cell in the “Netdirected Broadcasts” column to switch
on the Netdirected Broadcasts function for this router interface.
Deleting a router interface
Select a row and click "Delete". By doing this,
– you delete the row if it is a VLAN-based entry, or
– you reset the values in the row if it is a port-based entry.
Note: The prerequisite for resetting the values is the prior deletion of
other entries (if present) in the "Secondary Addresses" dialog.
To Next Page
Loading...
Need help?
General
