Redundancy
RM Web L3E
Release
6.0
07/2010
7.1
Link Aggregation
159
Parameter Meaning
allow static link
aggregations, and
When you connect devices using multiple lines, the Link Aggregation
Control Protocol (LACP) automatically prevents loops from forming. Select
Allow static link aggregation if the partner device does not
support LACP (e.g. MACH 3000).
Index This column shows you the index under which the device uses a link
aggregation as a virtual port.
Name Here you can assign a name of your choice to this link.
Enabled This column allows you to enable/disable a link aggregation that has been
set up.
Link Trap When you select “Link Trap”, the device generates an alarm if all the
connections of the link aggregation are interrupted.
STP Mode In the “STP Mode” column, select
on if you have integrated the link aggregation into a Spanning Tree, or
off if you have not.
Type - manual The partner device does not support LACP, and you have
selected
“Allow static link aggregation”.
- dynamic Both devices support LACP and you have not selected “Allow
static link aggregation”.
Note: If there are multiple connections between devices that all support
LACP, dynamic is displayed even if “Allow static link aggregation” was
selected. In this case, the devices automatically switch to “dynamic”.
Device Ports This column displays all the ports available for the link aggregation. You
can use the index to assign a link aggregation already created to each port.
Table 66: Link Aggregation
To Next Page
Loading...
Need help?
General
