Security
52
2.4
Restricted Management Access
RM Web
Release
6.0
07/2010
In the state on delivery, the device provides you with a default entry with the
IP address 0.0.0.0, the netmask 0.0.0.0 and all the management services.
This allows access to all services from any IP address. This allows you full
access to the device, even if a restriction is activated, e.g. to initially configure
the function. You have the option to change or delete this entry.
When you create a new entry, this entry also has these preset properties.
Note: If you activate the function and no entry in the table permits your
current access, then you can no longer access the management of the
device once you write these settings to the device.
If no entry allows access, nobody has access to the device management.
In this case, use the CLI access via V.24 to access the management of the
device.
To Next Page
Loading...
