Switching
RM Web L3E
Release
6.0
07/2010
4.1
Switching Global
91
The following table lists the duplex operating modes for TX ports together
with the possible error events. The terms in the table mean:
X Collisions: In half-duplex mode, collisions mean normal operation.
X Duplex problem: Duplex modes do not match.
X EMI: Electromagnetic interference.
X Network extension: The network extension too great, or too many hubs
are cascaded.
Address
Relearn
Threshold
Number of MAC addresses that are
learned at different ports within a checking
interval, so that if this number is
exceeded, the device sees this as a
relevant event. The interval for this check
is a few seconds.
1 - 1,024 1
Activate Duplex
Mismatch
Detection
Enable/disable whether the device reports
a duplex problem at a port for specific
error events. This means that the duplex
mode of the port might not match that of
the remote port. If the device detects a
potential non-match, it creates an entry in
the event log and sends an alarm (trap).
To detect potential non-matches, the
device evaluates the error counters of the
port after the connection is set up, in the
context of the port settings (see table 31).
On, Off Off
Variable Meaning Possible Values
Table 30: Switching:Global dialog
To Next Page
Loading...
